15194 Autoloader ALE: plate picker vacuum did not release in time, check air lines Platesetter_3244 Check if plate was really released. Check for oil in air lines and any other possible cause for air valve to be sticking. Perform Cal pvac (& cal uvac). NOTE: Vacuum thresholds are very sensitive to ambient temperature. Replace PPE board (or U15 ACD0838) if problem persists. aldly release may be increased to 1.5 seconds but this will directly affect the load/unload time. Resume. Inform Creo response center so that the problem can be checked at next p.m. inspection. If problem persists, call Creo service. During a load, the plate is released from the picker and allowed to settle onto the registration pins. After a timeout (release_delay), the vacuum value is checked just to make sure that it is at least below the grip threshold (pvt), (or release threshold for fw 2.26) if not then this error is reported, unsolicited. ../nvs/sat_cal_pvt.xmlNVS: sat pvt ../nvs/sat_cal_pvrt.xmlNVS: sat pvrt ../nvs/aldly_cal_release.xmlNVS: aldly release ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:32:56 2008 PST